Plastic pelletizing production line can solve some problems of recycling waste materials

Recently, with the rapid development of the plastics industry, some waste products are usually produced in the production process, so many manufacturers need to consider how to recycle these wastes. In some factories, some waste pipes are hand sawed into small pieces and then broken. In doing so, the recovery rate is very low. What can I do to solve these problems? Try using a plastic shredder and plastic pelletizing machine line.

How to cost-effectively recycle large-diameter PE plastic waste has become an important research topic for PE plastics manufacturers. Before starting the plastic shredder, it is necessary to strictly check whether the installation of the various parts of the machine meets the requirements, whether the bolt is loose, whether the belt is gently pulled by hand, whether there is a shell or like. At the same time, it is necessary to check the rotating target, and it is strictly forbidden to squeeze the inflammable and explosive materials to avoid accidents.

In the production of plastic pulverizing equipment, the average material should be maintained to ensure the quality of the crushing and normal production, and the motor overload is strictly prohibited to ensure the normal operation of the machine. In addition to the usual attention to check the looseness of the various components, the plastic shredder should pay more attention to the wear of the consumables. If the wear is severe, it should be replaced quickly to avoid damage to critical components and take necessary fire protection measures.

Due to the high speed operation of the plastic pulverizer, in addition to the precise and stable installation, good smoothness should be maintained to keep the machine running normally. Under normal conditions, it is normal for the bearing temperature to not exceed 70 degrees. The main bearings of the shredder are added with butter and molybdenum disulfide once a week.